How to three easy step to follow

The first step in the selection of the correct flow control valve is to set the main parameters of the process. In detail, the tool need the process fluid data (liquid or gaseous), an operation point (flow rate and pressures) and the piping size. These are the minimum parameters for a proper tool operation; the portal also allows to add additional information such as other operation points, inlet temperature, type of fluid and pipeline schedule. In the data entry form the web tool allows to set a specific type of control valve. On the right side of the web page the user can change the units of measure of the parameters.

After entering the main process parameters, the portal checks whether the specified valve in input is able to satisfy the conditions of the plant. If the field "valve type" in data entry was left blank the portal will seek which of DAFRAM Control Valves meet the process conditions specified in input. Other important information given as output are the size of the valve (different sizes of valves could meet the required specifications), the travel that meets the operating points (% of opening), the flow condition and the flow coefficient (Kv/Cv).

A further output of the web tool is the Flow Coefficient - Travel chart. Such information is of great importance since it allows to check the valve's percentages of opening that meet the operating points specified in the data input form.